Surprising ideas of HellermannTyton Tornesch – loose cables or sagging hoses are a nuisance for manufacturers of cars, aircraft, or household appliances. Long, HellermannTyton’s products in the automotive industry, in passenger shipbuilding, railway technology and the electrical wholesale are therefore indispensable. And who takes his household once scrutinized, quickly find a product by HellermannTyton. These applications range from cable kink protection of iron to the cover of the antenna for the car”, so the Hamburger Abendblatt. Especially the engine compartment of a modern car is a treasure trove in this regard”, because here too Kabelbundelungs – and fastening systems of HellermannTyton are used.
The company surprise through his ideas in customer service, product development and marketing. It is Europe to the first address “worked up, when it comes to products for bundles, attach, protecting and marking of cables and pipes. Large quantities and high quality standards in manufacturing demand fully automatic, precise tying, bundling, closures and fittings in connection with economic solutions”, communicated by HellermannTyton. The company will satisfy these demands by the electric-powered car tool 2000 and ATS3080 systems. Both tools enable a rational and cost-optimized production according to the company, they can bundle in seconds and automatically attach wire harness also fasteners. Applications are especially the Cable Assembly, automotive, the packaging sector as well as the electric appliances manufacturing. Both systems are for mobile and stationary applications suitable it can easily be integrated into automatic production lines.
Often wires and cables in areas would run, where traditional fastening solutions cannot be used. Especially for painted surfaces it is often not possible attachment points, as Screws to install bolts or holes. In these cases it is, to use an adhesive base; However painted surfaces for an optimal fit, require special glue”so HellermannTyton. For these applications high tack offer itself, the new series of fasteners with special glue. It thus enable optimum adhesion to difficult surfaces. The used adhesive consists of a single mass of acrylic and has a very good initial adhesion. The laying of cable harnesses must be under the conditions of modern work processes quickly and safely. Time problems do not arise, HellermannTyton have developed GW24 mouldings. Due to its special material composition, the innovative product basically spare an additional heating of the glue joints after complete shrinkage. The connection could be processed immediately after cooling. Molded parts reliably protect against moisture, pollution plugs, cables and wires, and provide strain relief. Products from the Material GW24 could even under extreme demands on the operating temperature and chemical resistance are used.